So at points the model wasn't even connected to itself. And I was so excited!! The ball inside didn't even print either, so I've fattened up the model and sent it back down to the printer.
Thursday, 13 September 2012
"Grow" FAILURE!
So ah.... I got my model printed FINALLY, and it turns out that my model was just a wee bit thin
So at points the model wasn't even connected to itself. And I was so excited!! The ball inside didn't even print either, so I've fattened up the model and sent it back down to the printer.
So at points the model wasn't even connected to itself. And I was so excited!! The ball inside didn't even print either, so I've fattened up the model and sent it back down to the printer.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment